PETG First Layer: Three Things That Matter

PETG is not PLA with a different temperature. It grabs the plate harder, strings more, and punishes both too much and too little squish. Copying a PLA profile across is the reason people give up on it.
Three things decide the first layer. Everything else is second order.
1. Squish, but less than you think
PETG wants less squish than PLA, not more. With PLA the common failure is the line sitting as a round bead; with PETG the common failure is the line being pressed so flat that it bonds to the plate permanently.
The test: the first layer should be slightly flattened, with visible but shallow ridges, and the lines should touch without a trench between them. If the part needs force to remove when cool, you are too close.
The practical adjustment is raising the nozzle slightly compared with your PLA profile, not lowering it.
2. The plate matters more than the setting
PETG bonds aggressively to smooth surfaces. On a bare smooth sheet it can take chunks of coating with it.
| Plate | PETG result |
|---|---|
| Textured PEI | Reliable release once cool |
| Smooth PEI | Strong bond; let it cool fully |
| Glass with glue stick | Very reliable, easily released |
| Bare glass | Bonds too hard, sometimes fuses |
The helpful fact: PETG releases on its own when the plate drops below roughly 30 °C. Waiting is a technique, not a delay.
3. Temperature, split between first layer and rest
A common mistake is raising the nozzle temperature to fix adhesion. Hotter PETG is runnier, strings more and bonds harder, which makes removal worse without improving the first layer.
What matters more is the bed temperature and keeping it steady. A first layer printed on a plate that is still warming is inconsistent at the edges regardless of nozzle temperature.
The reliable pattern: normal nozzle temperature, bed hot from the start, first layer slow, everything else at normal speed.
What does not help
- Glue for adhesion. On PETG, glue is a release agent, not an adhesive. That is worth knowing because people apply it expecting the opposite.
- More squish. Never the answer for PETG.
- Fan on the first layer. Keep cooling off for layer one regardless of material.
- Z offset from another material. Measure, do not copy.
When the first layer still fails
Work in this order:
- Clean the plate. Fingerprints matter more with PETG than PLA.
- Raise the nozzle slightly from your PLA offset.
- Check the plate is actually at temperature across its whole surface, not just where the sensor sits.
- Slow the first layer down — PETG tolerates slower better than hotter.
- Only then consider plate surface changes.
Most PETG first layer problems are the offset being inherited from PLA, or a smooth plate that needs a release layer.
FAQ
Why does PETG stick too well? Too much squish and a smooth surface. Raise the nozzle slightly and let the plate cool before removing.
Should I use glue stick with PETG? On glass and smooth PEI, yes, as a release agent. On textured PEI, usually unnecessary.
What nozzle temperature for the first layer? The same as the rest of the print. PETG first layer problems are rarely solved by temperature alone.
Does PETG need a slower first layer than PLA? Usually yes. It is more sensitive to being dragged while still bonding.
Can I print PETG on the same plate as PLA? Yes, but clean it between materials. Residue from one affects adhesion for the other.
内链:→ 首层诊断 / → PEI 板保养 / → 拉丝排查 CTA:If PETG keeps either sticking too hard or not at all, the plate and offset are the answer, not the temperature.