What Actually Keeps PETG Dry Between Prints

PETG absorbs moisture faster than PLA and prints worse when it does: fine bubbles, weak layer bonding, and stringing that no retraction setting fixes. The usual answer is "put it in a dry box". That answer is incomplete, and often the box makes things worse.
A dry box is a system, not a container
Three things have to be true at the same time:
- The desiccant is still active. Saturated silica stops absorbing.
- The box actually seals. A box with a loose lid exchanges air with the room.
- You did not put wet filament into a dry box and call it dry. Desiccant dries air; it does not dry a kilogram of filament quickly.
The common failure is the second one. A storage box with a snap lid and a gasket works. A tub with a lid that rests on top does not.
How to know the desiccant is dead
Colour-changing silica is convenient but the colour change can happen well before the beads stop absorbing. Two reliable checks:
- Weigh the beads before and after drying. When they stop gaining weight in use, they are saturated.
- Regenerate them at 100–120 °C for a couple of hours, then seal them while still warm.
If you have never regenerated your beads, they are almost certainly saturated.
The hygrometer question
A cheap hygrometer inside the box tells you the relative humidity of the air in the box, not the moisture in the filament. It is still useful: if it sits above about 20% at room temperature, the desiccant is not keeping up.
Do not trust a hygrometer that reads 10% straight after loading a wet spool. The air dried first; the filament has not.
What actually dries filament
Heat plus airflow, for long enough. A food dehydrator at 60–65 °C for four to six hours is the practical answer for PETG. Oven drying works if your oven holds a low temperature accurately; many domestic ovens swing well above the set point and will deform a spool.
Drying and storage are two different jobs:
| Job | Tool |
|---|---|
| Remove moisture from filament | dehydrator, 60–65 °C, 4–6 h |
| Keep it out afterwards | sealed box with active desiccant |
A dry box alone will not rescue a spool that has been sitting out for a month.
A routine that works
- Dry the spool before its first use if it came from an uncertain source.
- Print from a sealed box with a PTFE tube to the extruder if the printer allows it.
- Regenerate the desiccant monthly, or when the hygrometer climbs.
- Re-dry any spool that starts stringing or popping, rather than tuning retraction.
FAQ
Does a dry box dry filament? Slowly, and only if the desiccant is active. It is a storage tool, not a dryer. Use heat to dry.
How often should I change silica gel? Regenerate monthly in normal use. If the box is opened daily, more often.
Can I dry PETG in the oven? Yes, at 60–65 °C, if the oven holds that temperature. Verify with a separate thermometer first.
Why does my filament still pop after a night in the dry box? Because a night is not long enough and the desiccant may be saturated. Dry it with heat.
Is vacuum storage worth it? It seals well, but the air you trap is still there. Vacuum bags plus desiccant, then heat-dry before use.